TBWHL Printer Picture: 🖨️ High-Quality 1Inchx0.55Inch (26mmx14mm) Printing Solution Review

Because most of them Reviews seem to focus on the use of these clips in 3D printers, thought I'd do a review of the clips being used for their intended purpose. I used them to attach the glass and MDF backing to the drawing. The package contained many clips for this and several other projects. The clamps were solid as expected and worked as intended. They have slots on the back that appear to act as suspension mounts, but I don't think I would trust them with the weight of this piece. I'm sure…

I used them for the glass platform of the 3D printer. The edges are too sharp for me to consider comfortable on a PCB heated aluminum platform. However, with the help of a pair of pliers to bend the bottom side clip and some sandpaper to smooth out the parts where the plating has cracked from the bending, this is absolutely perfect. Easy to install and remove and the glass holds up great with only two, but I used three just in case. Would have been 5 stars if they had a protected or smoothed…

Some of my framed photos (metal frames) needed new clasps on the back. I've searched the internet for the ones I've used before, I call them "crocodiles". All you had to do was clamp them, press them in place and they fit snugly. You are nowhere. These were the only ones. There must be a trick to putting them on. I couldn't slide them under the glass and pad. If I tried to put them on the pad before putting the pad in the frame, they wouldn't hold. Bad design. No, I would not recommend them.