Review on 📱 Tempered Glass Film - JETech iPad Pro 12.9-Inch Screen Protector (1st/2nd Generation, 2015/2017 Model) by Corey Randolph

Perfect fit for iPad 12.9 Pro 2nd gen when installed properly. To achieve a lint and bubble free installation, here are a few tips. Try to find as clean a lint-free room/location as possible (no running fan/fan). Make sure to clean your iPad with the included microfiber cloth, or use a lint-free microfiber cloth and buff to remove fingerprints/smudges. Use the stickers provided or your own tape to remove any remaining lint. Follow the instructions for using the hinge/template stickers to help with installation. However, you can use your own tape to ensure the hinge stickers stick. I had issues with stickers peeling off on the first attempt to install. When removing the protective film and putting the protective film on the iPad, don't worry about air bubbles, worry more about the correct fit and no lint underneath. If the screen protector does not lay flat or has lint underneath, you can still remove the screen protector and try again. You can use a piece of paper to get under the screen protector and be careful not to touch the underside with your fingers when removing it. Once you have peeled back the protective film to your liking and there is no lint left underneath, you can start removing any air bubbles. Use the included paper scraper to remove air bubbles, starting from the center of the screen and working towards the outer edges. You will need to press hard on some areas and also use a microfiber cloth to rub/buff the areas. Just make sure you're applying pressure evenly and not in one spot to avoid damaging your iPad. Remember this is a screen protector. Even if you scratch them, you will be fine. I installed this on two different iPads and both had a perfect fit with no air bubbles, no lint and no damage.