Review on 💡 SEALIGHT H4/9003/HB2 LED Bulbs: Ultra-thin Design 60W 6500K White Conversion Kit with Fan - Pack of 2, 12000lm by Bob Taylor

I installed them on my old Camry 99 LE. Camry has these rubber boots to protect against water. To install them you need to do the following. 1. Disconnect the wiring harness from the existing bulb.2. Remove the rubber cover. 3. Disconnect and remove the old bulb.4. For a new bulb, remove the retaining ring as indicated. You can see I removed it in the first fig 5. Insert the lamp into the rubber boot so that the boot goes past the red gasket (in the first picture) and fits snugly against the fan housing, which you can see in the second and third pictures. 6. Insert the retaining ring into the lamp housing as follows and secure with a clip. 7. Align the bulb with the slots on the retaining ring using the two locks/keys on each side. If you look at the third photo I posted, the lock/key is to the right of the wire coming out of the fan housing. Align, press and rotate clockwise to secure.8. Connect and test.9. When you are sure it works, put the case back on the case. After figuring out how the cover would sit on the lamp itself it was fairly easy to install. It's daytime so I'll have to post a brightness picture later.