Review on 🔌 Plug N Play Remote Starter for Frontier 2008-2019, Start-X Brand, 3X Lock Remote Start, 10-Minute Install (with Immobilizer) by Ricardo Thotti

That's exactly what it says. The video shown with it is all I used to connect everything. Very easy to follow. Giving 4 stars as they claim you don't have to remove any panels to install this. Now you could if you knew exactly how to disconnect all the necessary wiring harnesses. I read a review that says you need to remove the faceplate which is under the steering wheel. I started out not doing it, but ended up removing it. After that everything went MUCH EASIER AND FASTER. Most wiring harnesses are easily disconnected. The big white on the BCM was the hardest. There is a tab that you cannot see and that you have to click to unblock. It is not visible when viewed from below. If you remove the panel, access is much better. Wire harness 2 on BCM for disconnect is black which requires some fiddling. Although not bad. All in all it took me about 30 minutes plus or minus to assemble. Demonstrative under and hour. I really like that it comes with zip ties to secure everything. Removing the panel will make it easier to secure all the cables and the computer under the dash. It all went into my 2017 Nissan Frontier. Another thing I found; If you do not want the horn to sound when using this horn, simultaneously press and hold the lock and unlock buttons on the key fob until the parking lights begin to flash. This will turn off the beep for the lock function. Repeat to re-enable the horn. Hope this all helps.