I used a gray plastic wall switch housing to place the shunt. I used a dremel tool to open up the side to place the shunt and used zip ties to secure it. I mounted this box to the wall very near the connector where the negative load terminals connect with a #2 wire about six inches long. The battery wire on the other side is about a foot long. Then I used 2 two core cables with red and black wires. I used two black wires for the terminals connected to the shunt side on the battery side and one red for the shunt on the side connected to the load side of the shunt and the other red for the positive supply or the meter. . (see photos) This enabled me to place the measuring device on the wall so that it was easy to read. The readings are very accurate and show the same numbers as my Wattsup RC hobby meter.
Tire Hankook Ventus Prime 3 K125 215/55 R17 94W summer
10 Review
HOTSYSTEM Universal 2Inches 52Mm Single Hole Dash Dashboard Gauge Meter Mount Pod Holder Black Cover For Car Exhaust Gas Oil Water Temperature Temp Voltage Air/Fuel Ratio Turbo Boost Gauge
14 Review
HOTSYSTEM Single Hole Dash Dashboard Gauge Mount Pod For Car Temperature, Voltage, Air/Fuel Ratio, Boost, Exhaust & More - Universal 2 Inches 52Mm Size With Black Cover
11 Review
Upgrade Your Dashboard With HOTSYSTEM Universal 2Inches 52Mm Dual Hole A-Pillar Gauge Meter Mount For Car Auto
12 Review
3-Compartment Cargo Trunk Storage Organizer By EPAuto: Maximize Your Car'S Storage Space
28 Review
Motrobe Door Side Storage Tray For 2023 2022 2021 2020 2019 Dodge Ram 1500 Crew Cab Driver And Passenger Door Armrest Pocket Insert Organizer Set Of 4
30 Review
2 Pack JOYTUTUS Coin Holder: Universal Car Change Organizer For Most Trucks Accessories
27 Review
Transponder "T-Pass" TRP-4010 AVTODOR TOLL ROADS, black
46 Review