Review on BCZAMD Upgraded Cartridge Accessories Extruders Additive Manufacturing Products by Brent Ayyagari

Name: BCZAMD Upgraded Cartridge Accessories Extruders Additive Manufacturing Products
Item: BCZAMD Upgraded Cartridge Accessories Extruders Additive Manufacturing Products
Rating: 3

August 26, 2022

Cheap and good - 3D printer accessories

I've used this for probably less than 200 hours printing at 230C for PETG and the first of the three has already stopped heat. It's not too expensive to replace, but it's the time it takes to replace any of them. Working with a wire loom is a pain. If you buy this make sure you don't connect it to the rest of the wires so if it burns out it will take 5 minutes to replace instead of an hour. The cable gets very hot, so take that into account when placing it and you'll hear the fan shroud cooling your parts. The printed PETG fan shroud will deform over time from contact with wires, and because it's so thick it's hard not to hit it.

Pros

3D printer parts and accessories

Cons

Legacy model

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

Befenybay 2020 Upgrade: X-Axis Synchronous Belt Tensioner For Creality Ender-3/Ender3 Pro/Ender3 V2/CR-10/CR-10 V2/CR-10 V3/CR-20 Pro –Straighten And Stretch For Enhanced Performance

4.18

50 Review

BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)

1.94

7 Review

Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards

4.14

19 Review