Header banner
Revain logoHome Page
Josh Long photo
China, Beijing
1 Level
671 Review
66 Karma

Review on πŸ–₯️ HUANUO Monitor Wall Mount: Full Motion Gas Spring Arm Stand for 24-35 Inch Screens - Adjustable VESA Bracket, Max Load 26.4lbs by Josh Long

Revainrating 3 out of 5

Nice Arm Computers & Accessories

These hands fit my project perfectly. I ordered 3 of these for a 27" monitor. Pay close attention to the spacing between the brackets and use a cardboard cutout the same size as your monitors to determine the width of the spacing between the brackets. The picture shows that the external mounts are at their limit but I wanted the monitor mounting plate to screw to the stud.As you can see in the picture I used a piece of wood to screw on the monitor mounting plate and then screwed the circuit board onto the stud screws. Use a stud locator with the ability to locate electrical wires before screwing anything to the wall. Screwing into the studs makes the monitor arms strong. Screwing the brackets to the circuit board and attaching to the pins makes them one strong and durable platform.The brackets can easily bear the weight of the monitors.and you can take the tension ei n if you want to move the monitors horizontally, but I don't do that kind of work. The cable management system works and you can remove the cable management clips to route the monitor's power cable and signal cable. by no problem. Your desktop will have more free space to place trash, and floating monitors look very cool. Measure, measure, measure. This project took 3 hours to find a bolt, choose the right length board and install the monitor mounting plate onto the board. I would advise you to get some monitor mounting screws that you can finger tighten and there is no right length as you can over tighten and damage the monitor. You will need to go to your local hardware store to get additional 6" x 2" coarse thread screws. Remember that fine carvings are meant for hardwoods like maple and oak. Concrete or cinder block I recommend getting steel anchor bolts and not using plastic expanders. Although the guy at the hardware store recommends plastic for your project, insist on using steel. Pay extra for peace of mind. Good luck

Pros
  • WIDE COMPATIBILITY - This Vesa mount fits monitors from 24 to 35 inches and weighs from 6.6 to 26.4 pounds (3-12 kg), compatible with Vesa 75x75, 100x100, 200 x 100, 200 x 200.
Cons
  • New competitors have appeared