Review on 💎 500g Upgrade Crystal Clear UV Resin: Jewelry Making Craft Decoration - Transparent Solar Cure Sunlight Activated Epoxy Resin for Mold, Casting, and Coating by Tara Ford

This resin gets TOO HOT even at low UV temperatures, when this happens it causes the following problems: Thin casting: Even thin casting is not possible, it warps and creates huge holes, crevices and bubbles. Thin/dominant: Even using a product with a VERY THIN LAYER is terrible - the resin is heated so much that it becomes more liquid and runs off wherever you apply it. When I used it as a thin layer for the piece's dome, it completely deformed my finished resin piece because it got very hot on low heat/short interval (40 seconds). After my first issue with it I had to adjust to get it back but I REALLY tried to get it to work with the thinnest layers but even that resulted in damage to my products. Please return within 24 hours of delivery. I will never use this brand again. but this also resulted in damage to my products. Please return within 24 hours of delivery. I will never use this brand again. but this also resulted in damage to my products. Please return within 24 hours of delivery. I will never use this brand again.