Review on Godox 22X90Cm Honeycomb Lighting Speedlite by Justin Jeppi

reviews are true, this product is not friendly in the assembly department. It doesn't come with instructions so you're left with a bunch of holes and poles. I have some tips on how to assemble it faster without breaking anything. Preliminary Steps: Look at the photo of the flange into which you will insert your rods in [1][3] and [2] as you complete steps X. Assembly: 1. Work on one side first, no matter which side.2. Insert one end of the pole into the corner of the softbox. (see photo 1). Repeat for the other pole. You'll find that I'm deliberately avoiding the middle loop here, and for good reason, because if you do, it's nearly impossible to build without a lot of effort. After inserting one end of the rods into the softbox, align the flange and insert the rods into [1][3] and [2]. It doesn't matter how the flange sits in this position, so make sure you use these numbered holes. Now one page is set.4. Work on the other side, repeat step 2. Insert the end into the softbox first.5. Now the hardest part is inserting the other rods into the flange. I suggest stepping lightly on the flange to get a solid base. You can then pull the rod slightly and insert it into the desired hole. You will find the other side leaning towards you. This is normal, but do not pull OVERFULLY. You will find that this position makes it easier to insert the rod into the flange. Disassembly steps: 1. Place the configured softbox on the floor with the flange on the floor.2. Grasp the corner and push the bar down a little while tightening the corner.3. Repeat for the other corner. The rest speaks for itself. Thanks for reading, I hope the above helps.