I think I understand why people struggle with this. The wire cover is held with a band around it to keep it on the wires. This puts stress on the wires themselves. It does 1 of 2 things. He can either pull the connectors off the circuit board or slide the cable cover down so the cables rub against the sharp edges of the case inside. Both scenarios will fail. To fix this I raised the wire cover in the case as it should and then used Permatex Right Stuff to close the wire hole and support the weight of the wires and wire cover. I then used fabric harness tape on the exposed ends of the wires to secure the wire cover to the wires. Now the wire cover and case body fully support the wires and prevent them from being damaged. This is a simple fix that should keep the wires intact and the speedometer working properly.
Room temperature and humidity sensor Xiaomi ClearGrass Bluetooth Thermometer white
13 Review
Table lamp Camelion KD-017A black
11 Review
Universal 52Mm Single Hole A-Pillar Gauge Meter Mount Pod Holder With Black Cover For Car Auto By HOTSYSTEM
10 Review
HOTSYSTEM Single Hole Dash Dashboard Gauge Mount Pod For Car Temperature, Voltage, Air/Fuel Ratio, Boost, Exhaust & More - Universal 2 Inches 52Mm Size With Black Cover
11 Review
2 Pack JOYTUTUS Coin Holder: Universal Car Change Organizer For Most Trucks Accessories
27 Review
2Buyshop 2 Pack Car Tissue Holder - PU Leather Napkin Box For Sun Visor & Backseat - Black
28 Review
3-Compartment Cargo Trunk Storage Organizer By EPAuto: Maximize Your Car'S Storage Space
28 Review
Gray Multi-Functional Portable Steering Wheel Tray For Car Laptop And Food - Vehicle Seat Mount Table For Notebook, Eating, And Working On The Go
43 Review