Review on 💻 Pantum M6552NW Laser Multifunction Printer with Wireless Networking and Mobile Printing for Large Paper Capacity in Monochrome by Miyazaki Kiyoshi ᠌

We bought such a house (before that there was Samsung), It was necessary that there was a Wifi client (so that it would normally roll into the home network via Wifi, and not by wire) and AirPrint was supported. there is Apple technology with which you also want to print and scan. Citizens, comrades. These Chinese have created such a fierce trash in terms of software that in order to connect this unit to an existing network, you have to dance with a tambourine for a very long time. Yes, it has direct Wifi printing, but this is a different network, it does not have the Internet and you need to connect to it every time you need to print. The application from the manufacturer did not help in any way. When trying to set it up on an existing network, the setup options page doesn't show up at all. You can’t do this from the menu either - only WPS and he didn’t want to work even with the most common Zuhel Kinetics. It connects only this way: we connect it BY WIRE to the router, it receives an ip address, we go to the web face using it, there we climb into the settings and set the network name and password. There is no “save” button there, in principle, only the “active” checkbox. Wifi turns on as soon as we take out the cable from the LAN port. Connected, yes. BUT God forbid you press the Wifi button on the printer. All. It will fall off and will no longer join your network without repeating the same procedures. This is horror. Fear and horror. I have never seen a more raw device in terms of software. If you want to print and scan over Wifi normally and reliably, don't buy this Pantum for anything. Anything else is better, but this is not a mockery. PS An acquaintance works in the service, who repairs office equipment, says there are no spare parts for them, in principle, from the word at all. Not for any money. Conclusion - disposable and raw you know what.