Review on POLAR H10 HR Sensor: Bluetooth Enabled, 🏋️ Black, M-XXL – Advanced Accuracy for Heart Rate Monitoring by Eh Pyaw Paw ᠌

Acquired with the intention of using it for running on the Oxygen T12 treadmill. While I stand here connected, it displays the pulse. The phone and the track both exhibited the pulse at the same time. As soon as I start to run, the pulse indicator on my phone begins to increase, however on the track it only shows about half as much and disappears frequently. I also tested it out on a different track, which was called Harizen Adventure 5. The identical thing When the runner reaches the centre of the moving belt, both the signal and the pulse begin to weaken. I forwarded it to the SC, and we will see what action they take. Displays the pulse merely a half meter away from the track console in a stable manner. Thus far disappointing. collected from the location of the service center. On one piece of paper, the repairman wrote that he works up to one meter, while another piece of paper showed that he works at seventy centimeters. He requested that the repairman demonstrate how he operates from a distance of one meter, but the repairman did not pay him. But, because this is the only SC in Hong Kong, the repairman took the stance that everything is functional, and if there is something that I don't like, I am free to conduct my own examinations and lodge my complaint with whoever I choose. If you intend to purchase it for a large number of gymlink simulators, then there is no requirement for you to do this step. Due to the low power of the transmitter, it can only communicate with the simulator's receiver when they are quite close to one another (70 centimeters). I have no idea what they were thinking when they developed such a flaw as a gift for simulators with which it does not work. I don't know what they were thinking. In the course of thirty minutes of operation, the sensor is only likely to derail itself between two and four times if it is hung on the edge of the track. Because the readings are only transmitted from a very close distance if you hang it straight forward, it appears that either the antennas in the sensor are placed incorrectly or those that radiate forward do not work. If you hang it straight forward, then the readings are transmitted. When it has been running for thirty minutes, it disconnects from the Bluetooth connection a couple of times whenever it comes into contact with the phone. When boiling occurs, there is a sudden drop in the pulse rate of between one and one and a half to two times. I posted on the off site, where it says that they will always respond, yet they did not answer my post. As a consequence of this, I am able to advise you that due to the sensor's poor connection, you should not carry it with you when you run on a treadmill that has pulse-dependent programs. I would never consider purchasing a Polar product due to the subpar quality of the service center located in Hong Kong.