Header banner
Revain logoHome Page
Dave Rasic photo
1 Level
1261 Review
44 Karma

Review on Befenybay Z Axis Linear Actuator Printer by Dave Rasic

Revainrating 2 out of 5

Not assembled properly

This nut is for backlash adjustment. The set screw needs a nut in the cutout as you see in the picture. When it was sent to me this nut was on the set screw outside of the cutout. I had to disassemble everything to get to this nut. Then reassemble it after making adjustments. It took some time. I'm too old for this.

Pros
  • Linear Motion Products
Cons
  • Not as thick as other picks