Review on Ethernet 🔌 Plated Network Connectors by Kristen Cunningham

I used Cat 6 23 AWG copper wire with these connectors. grasp and unfold each of the wires). Third, arrange the wires in order and work with them until they lie flat. Fourth, thread the connector, check the order of the wires and make sure the cable is fully inserted. Fifth, cut the wires (use pads or a utility knife). If they stick out a bit, pull the wire slightly. Sixth, crimp the connector. Seventh, check the connection with a tester (I used a cheap one). wires in the right order. It's easy to knock out, but easy to see with the pass-through connector. Also, lengthening the wires makes them easier to work with. I haven't had any issues with these connectors and I really like them.