Review on Tech Armor iPad Air 3 (2019) and iPad Pro 10.5 inch Screen Protector - Ballistic Glass, Case-Friendly, Ultra-Thin, Scratch & Impact Protection [1-Pack] by Micheal Looney

Easy and error free installation, just take your time and ensure the screen is spotless and smudge free and the work area is lit very well and is set Ahead, I used masking tape as a hinge method to align the screen protector perfectly. There are several YouTube videos demonstrating this method and it works great. A few strips of packing tape and everything is there. The second step is to wash your hands thoroughly with dish soap and dry them. The third step is to stick masking tape to the bottom of the iPad. The fourth step is to align the screen protector over the iPad screen and make sure it is exactly where it should be, then wrap the tape tightly over the screen protector. I needed a suction cup to reopen the cover like a book. Step 5 Clean, clean and clean again with the provided alcohol swab. And leave to dry and wipe with the included microfiber cloth. Step 6 is to take strips of tape and tap all the way around. In fact, I carried a work light and illuminated the entire screen with it to check for contamination. As soon as I thought it was perfect, I saw a stain using this method. In the end I found nothing else and it was time to install. Step 7 should have been to peel off the protective cover and without touching the side that attaches to the iPad's screen and folding it over the screen the tape is already holding it in place where to put it, so you should be good to go. After pressing the center of the new screen protector you will see the adhesive magic happen, most of the air should come out, just let the rest of the air out, remove the tape loops and bam. You too should have a screen protector that looks like it was factory applied, like mine. Much luck!