Review on 🎮 Rinbers JDS-030 USB Charging Port Charger Socket Board with 12 Pin Cable for Sony PS4 3rd Generation Controller by Duane Hayes

After installing the new charging port component it worked great! Press and hold the PS button for a few seconds to drain residual power from the controller. 2. When installing the new charge connector component, align the connector with the connector hole. There are 2 holes on the component to help align and install the board. Be sure to press them firmly so that the plastic frame inside the case goes through the hole. hole on the board, then fasten the screw in place. 3. Align the folds of the old ribbon cable with the new one, gently insert both ends of the ribbon cable. Assemble the controller carefully, don't forget to put the battery back into the motherboard. Much luck! 😄