Probably should have known how to install this item on the shaft. There were no instructions for it at all. After finding out that it was slightly less bored than the 3/8" shank I had, I figured it needed to be heated to expand it so it would slide onto the shank. Anyway, I did made and then lubricated. From the moment it was heated the factory grease burned out. For the quality I still give 5 stars. Very well made and should last a lifetime.
💍 Silver Coupling Connector Accessory Fittings
3 Review
💑 Urethane Elastomer Nominal Coupling for Lovejoy Applications
3 Review
🔩 Durable Solid Steel Plated Shaft Collars Set for Efficient Industrial Applications
3 Review
💥 Climax 2C 200: The Ultimate Two Piece Clamping Plating Solution
3 Review