Review on 📺 ECHOGEAR Swivel Full Motion TV Wall Mount Bracket for 26-58 Inch TVs – Extend, Tilt, and Easy Single Stud Installation by Warrick Dembo

My goal was to mount a 50 inch flat screen in a corner. This bracket now holds my new Samsung 50" with 1-2" extra on each side of the TV. You can see in the photo that the bracket can be rotated further to give the TV more hanging space, or rotated sideways and hung flush with a wall. I have a rack 16" from the corner plus mounting brackets. Another 16" from the wall plate to the TV mount point, allowing the center of the TV to hang right out of the corner, which also meant the mount was almost perfectly perpendicular to the wall (no side tension lever that would make me nervous) The build and design is impressive so installation was easy and reliable They included a wide range of screws so you have exactly what you need depending on your TV including spacers for round back tvs; very attentive. There is one negative review on the tilt mechanism - it says the clamping handle is too long and comes in contact with the tv so the tilt plate cannot be fully tightened. This is incorrect. The handle is a spring loaded hex key that is simply pulled straight along the shaft, adjusted and then tightened en must. It's smart. I mention this because it was my only concern and I was amazed at the quality and attention to detail of this mount. I like the 'hook' plate which allowed me to lift the TV onto the mount, 'hook' it, then free both hands to level it and tighten two more hex screws. Excellent work.