Review on 22Mm Engineer Stainless Straight Bracelet by Curtis Kincade

As mentioned, this is a very strong watch strap. It looks like it's made of lead. Normally I would consider that a plus as it gives a sense of quality. However, my watch has a lightweight titanium construction. I switched to this from a leather strap (which had rotted after years of use) so it was a bit of a shock. It comes with two large strong spring pins. In my case, I couldn't install one of the two pins because the bracelet was hitting the side of the watch, preventing the holes from matching. Just a fraction of an inch, but it was enough. I just replaced the big fat needle with a thinner one from my leather bracelet. The slight difference in diameter made it fit. Sizing wasn't difficult. The jewelry screwdriver set included a regular screwdriver, small enough to remove two links in my case. Please note that some screws have become loose, so it is advisable to check them from time to time. I like the matte finish on the outside as it hides scratches better than a glossy one. (I'm usually picky about my watches, the titanium is riddled with scratches, but the sapphire is still flawless). -Drive GN-4W-S.