Review on 📱 TotalMount Hole-Free Remote Holder - No More Wall Damage (Black, 1 Unit) - Holds 3 or 4 Remotes by Zaine Davis

Pros: - Helps to organize lots of remotes that were never where I needed them - Good fit and finish with 2 dividers for 3 remote versions (see below) - 3M command strips (4 for 3 Remote control versions ) that work well on smooth surfaces like the bedside table. 3 screw holes and 3 screws are also included if you want a more permanent installation. - Dustproof holes at the bottom. At first I thought they were for smoothing out the glue as they are curved on one side. However, they fit into grooves on the inside of the remote control holder. Don't throw them away. I read several reviews complaining about the remotes falling off. Well I think they would if the baffles weren't installed. fingerprint magnet It's okay if you just plug and unplug the remotes. However, the glossy plastic coating will show all the fingerprints. That's not enough for all remote controls. Yes, it works with Roku, Apple TV, Google 4K TV or slim LED strip remotes. However, it is not suitable for remote controls thicker than 1.5 inches. For example, it is not suitable for the TiVo remote control. - Quite expensive for what it is: a few plastic parts. - The floor is not flat with dust. Openings and overall configuration. If spacers are not installed, remotes tend to fall off. Even when mounted, they can rest on the spacer. All in all, if cost isn't an issue, this works and serves the purpose of adding a bit of organization to the pile of remote controls that most have everywhere. It would have been better if it was made about 1/4 inch lower to accommodate slightly thicker remotes like the TiVo.