Review on 🔧 Enhanced Performance: Creality Compression Springs Connect Leveling for Optimal 3D Printing Results by Vedavyas Fleming

I only have one printer to start with and that's my hobby/interest. I am not a self proclaimed expert and have hundreds of videos on YouTube. I bought these to replace the OEM on my Ender 3 Pro. -- These yellows are definitely thicker and harder than the original grays. -- With OEM springs, I had to realign each impression. With these replacements I only have to realign every 3 or 4 prints unless I pull the prints off the bed instead of removing the magnet mat and then the mat. ==Removing the expression from the bed will always mess up the level.==The pictures show these ender springs, but is there a photo of one of them in a bike shock? I'm not sure, but that's definitely a job for the Ender 3 Pro bed. I only need 4 not 6 or 10 but I can use extras in some of my RC chassis models so they aren't just a waste. then spend 10x more on the BL Touch, but for a few bucks, checking the level every few prints is enough for me. I'm the sole owner of the printer and it's a hobby so I don't feel the need to spend $50-70 for a BL Touch. If I had 3 or more printers or print one piece at a time (side job?) then I would forget about the nibs and just touch them (or buy more expensive printers if it was for a side job.) jmho