Review on 🚗 Enhanced EVO-CHRT4 Stand-Alone Add-On Remote Start Car Starter System for Chrysler Dodge Jeep Fobik Smart Key Vehicles by Marquel Henry

Product works great and meets expectations. One of the sellers offer to pre-flash your car, if not, you also need to buy a flashing tool, otherwise it won't work. As soon as I received it, opened it and looked at the instructions, it was scary. It didn't look like plug and play (but it was, see later). There are 3 wires to look for: - Yellow for Ignition: This is the only one I had to connect between the 20-pin pin and the T-harness. Use one of these screw plugs to connect them. - Blue for hood pin: This is optional and I didn't do it. In principle, you cannot switch on the engine remotely when the bonnet is open. - Brown for marker lights: I didn't understand that, so I didn't do it. You need to connect a 20 pin wire to the parking light wire so that the light turns on when ignited(?). I didn't join them and my headlights still shine perfectly. I have a push to start the car and the only annoying thing is that when you get in you have to press the start button twice to start driving. The manual doesn't mention this, so luckily I read it on the forum. It makes sense, and probably this product can't/shouldn't do anything about it (particularly for safety reasons), but I'd like the instructions to be clear on that. Last point, and this applies to my car (so maybe not yours), I had to remove all the panels under the steering wheel to get access to the ignition wire. Be sure to check it out before you buy so you know what you're getting. It's worth it!