First a little insight. I have a 2018 JLU Sahara. It has no fenders between fender and bumper. I was also unlucky enough to have a package that included LED headlights, LED taillights, yes. I parked my Jeep facing the inside of the garage and turned on headlights one by one. This allowed me to save the default projected lighting for adjustments. The instructions assume you already have fog lights. Tip: Do not remove the protective plastic from the lenses until you install the headlights. The product appears to be of good quality. There are only two problems I could see with these lights. 1. The rubber grommet that holds the positive water/moisture proof wire was not installed correctly on both lights. Will this cause problems later? Only time will tell.2. The adjustment screw is out of reach. It forces you to remove the flashlight, make adjustments, turn the light back on, take the light out, make adjustments, turn the light back on. The OEM adjustment screw faces rearward and the LED faces down into the bumper. I'm sure it's because the LED light has more depth. Installation: Installation was pretty easy. Took me about 2 hours. I switched to the correct brackets (JL) before. Tools needed: pruning shears or flathead screwdriver. head 8mm. head 7mm. Philips screwdriver. I also removed the two under the bumper and the trim strip between the bumper and grille. Loosen the angled screw holding the brush guard. The fender slides out by pulling it sideways, but not without sliding back the plastic guide rail on the underside of the fender. After removal, remove the standard fog lamp. Connect the pigtail to the Jeep's wiring and plug the LED light into the bumper (do not screw in yet). Turn on the fog lights and adjust the height to match the factory light. Another option is to park on a level surface 25 feet from a wall. Measure the height to the fog lights and then adjust that height to the wall minus 4 inches. The top of the fog light pattern should match this measurement. With the light adjusted correctly, screw in the new LED fog lights. Repeat the same process on the other side. When you're done, put everything back together and remove the protective plastic wrap from the LED lights. You can remove this with a small piece of tape or your fingernail.
1999-2002 Chevy Silverado/Tahoe Headlight Assembly - 2 Year Warranty!
27 Review
Black Bezel Halogen Type LED Halo Ring Eye Lid Projector Headlights For 2006-2008 BMW E90 3 Series 4 Door Sedan
32 Review
09-14 Ford F150 DRL LED Tube Dual Projector Headlights - AlphaRex Base Model Jet Black With Smoke Lens
23 Review
Pack Of 2 TMH 6 Inch Oval White LED Lights For Truck Trailer With Reverse Lamp, Turn Signal, Side Marker And Tail Functions - Surface Mount, Ideal For Trailers, Buses And Vehicles, 12V DC
25 Review
Upgrade Your Headlights With H1 LED Bulbs: 8 Sides CSP Chips, Super Bright White 6000K And 12000LM For High/Low Beam And Fog Lights - Get 360 Degree Lighting
40 Review
Front LED Turn Signal Light Compatible With 2007-2017 Jeep Wrangler JK | LITEWAY Fender Side Marker Parking Lights
50 Review
10 Pack BRISHINE 194 LED Bulbs - Extremely Bright Ultra Blue 5630 Chipsets For Car Interior Dome Map Door Courtesy Trunk License Plate Lights
40 Review
12 Pack - WEIMELTOY Red LED Car Bulb 194 With 3030 Chipset & 2 SMD T10/168/W5W Wedge Light Bulbs, 1.5W 12V For License Plate, Courtesy, Step & Trunk Lamps, Clearance Lights
36 Review