Review on 🔒 Enhance Workplace Safety with EONLION Replacement Flexible Nozzle Stopper Occupational Health & Safety Products by Austin Arvayo

Waste of time and money. One of them broke before I put it on the tin. The plastic is so cheap and feels flimsy. The black didn't match my lenses and the yellow supposedly matched my lenses. The yellow cap is difficult to unscrew. It's so difficult to string I figured I'd split it in two by just tightening it enough so it wouldn't leak. I ended up putting them back in the box and am happier that I modified the factory gas canister nozzle. Now I have a free-flowing nozzle with no leaks, and it's not because of those junk parts. I also noticed that they don't even match the specs of the original can liner. You could tell by the nozzle itself that it was a completely different size. I removed the gaskets on both at the bottom of the injector, this is the part that comes in contact with the snap ring. I compared them side by side and then pitted them against each other and the size is definitely not the same as factory size. This end of the nozzle is smaller than the factory end. This could be why one of the shafts is leaking no matter how tight or loose you get it, or why it's almost impossible to put the nozzle retainer ring on. I'm sure there are good glass attachments out there but this isn't one of them, beware of that cheap junk.