Review on ACDelco Professional 8-6710 Windshield Washer Pump, 3.59 in: Efficient Cleaning for Clear Vision by Adolfo Goins

The native pump is cracked and expensive washing liquid is dripping everywhere at the entrance! It took me an hour and 20 minutes to figure out how to get the tank out and diagnose the problem. It took 20 minutes to open the wheel and put everything back in place once the part arrived. Since I was able to track the delivery, I met a Revain courier on the side of the road and installed the part straight away. the dirt that got into the line when you changed the pump. The left wiper worked perfectly. In the year I've used the washing machine maybe 150 times, the right side spatters and the left side is adequate but not very good. At the moment I think the OEM AC/DELCO part was a better choice than this cheaper AC Delco branded part. Currently, it is very difficult to determine whether spare parts are counterfeit or counterfeit. Another reason to bring the automotive supply chain back to the US! The pump comes with a new seal and with a slight wobble it snaps straight into the reservoir. The top of the pump can be rotated to ensure all connections are properly aligned. Plugged in, started the car and checked. Works perfectly. A few installation tips: 1. Remove the inner wheel arch cover and the right front headlight assembly.2. Remove the container spout. It pulls straight from above.3. Locate the four screws holding the tank in place. Loosen, but do not remove, the mounting screw, and then remove the screws that secure the canister. You can turn the bracket sideways without removing it from the vehicle.4. Pay attention to the position of the level sensor, the electrical connection of the pump and the drain hose. It is important to ensure that the new pump is rotated in the same way when reinstalling. Disconnect plug.5. Remove the canister and inspect for tears or holes. Rinse well to remove debris.6. Install the pump inlet seal in the tank. Wet (spit) the gasket to make it easier to slide into the hole.7. Insert the pump inlet (bottom) into the gasket and snap the top pin of the pump into the slot on the reservoir.8. Connect the electrical connector, level sensor connector and outlet hose.9. Follow steps 5-1 in reverse order. Tools Required: 7mm socket or combination wrench. 10mm socket and ratchet.