Review on VLAND Tail Lights Assembly: Toyota 86 2012-2020, Subaru BRZ/Scion FRS 2012-2019 | Sequential, Full LED, Plug-and-Play, Red by Andrew Young

Shipping was a lot quicker than originally thought so thanks for that! Installation takes ten minutes per side, but that's only because you have to re-solder two connectors on the back of the flashlight. . Luckily, as you can see from the photos, the crimped ends can be snapped open just enough to release the wires and then swapped out. (Green and yellow came out of the box upside down). Crimp, then lower again and you're done. You will need an 8mm deep socket and a torque wrench to properly tighten the 4 nuts to 3.3 ft lbs. The case comes with a new factory seal, saving you $22 trying to buy original seals. big! No leaks and they were a dream come true!