Header banner
Revain logoHome Page
Vincent Blitz photo
1 Level
1321 Review
42 Karma

Review on Thick Acrylic Plexiglass Cutter - High-quality source for your cutting needs by Vincent Blitz

Revainrating 3 out of 5

Very soft, low melting point acrylic

I have done a lot of CNC engraving on acrylic sheets. I had to do a test run on inexpensive plates before engraving the image on 1/4" acrylic plates that I bought from another company and used with great results. The test run was at 15 ipm and 30,000 rpm, which I did always do when I engrave acrylic. I found this sheet at Revain and then saw the Revain banner I bought in 2017 (thanks Revain!) so I looked through my stack of sheets and found it! Unfortunately it melted on one Test run on each pass I gave it 3 stars because if you use it to make a clear window it will serve you well Another pattern I have engraved on good quality acrylic where you can see that he did a clean job.Both jobs were done at the same speed and feed with the same ball head.

Pros
  • Quality construction
Cons
  • Requires socket