Review on 🚗 2012-2014 Toyota Camry LED DRL Projector Front Lamp by MOSTPLUS by Klassic Duncan

Warning, not (plug/play!) After troubleshooting I managed to get it working properly. I considered returning the headlights a few times, but that was the look I was going for, so I decided to work on it. #1. This item doesn't come with low beam, you need to buy them by yourself. I ended up buying two Silverstone (H7) low beams because they are the only ones that will fit the new headlight assembly. Install them and save them in place #2. The original car connector does not fit properly with the low beam connector. To connect, you need to push the two metal connectors of the low beam close together and then connect to the connector of the low beam. It will work! #3. Left and right turns require you to use your original signals. Not the ones that come with the kit. Your original turn signals will NOT fit the new headlight assembly. You need to buy a good sealant. Be sure to seal the left and right turn signals well to prevent water from entering. #four. Follow these steps and it will save you hours trying to figure it out! Try it before you assemble everything. Much luck. Hope this helps, this method worked for me Toyota Camry 2012 SE.