Review on 🚗 Walker Exhaust CalCat Carb 82663 Catalytic Converter - Direct Fit by Logan Broadnax

I bought this to match the 2000 Woodsman. I also needed a Walker 31310 exhaust gasket for the front of the catalytic converter and a Walker 31357 exhaust gasket for the back of the catalytic converter. Since I was installing a new catalytic converter, I also replaced the front oxygen sensor with a Bosch 17018 oxygen sensor and the rear oxygen sensor with a Bosch 13469 oxygen sensor. Getting the front mounting bolt on the back was much easier than the OEM Cat I because the heat shield was slightly smaller . The only bad thing I can say is that the middle suspension bracket didn't line up well enough with the suspension on my car for the bolt to go through the hole, but at least the two outermost flanges matched perfectly. My check engine light went out on its own after about 50 miles and the smog passed.