Review on 📸 SnapIt Brackets for SnapIt Photo Backdrop Board: Enhancing Flat Lay and Food Photography Backgrounds - Durable Realistic Backgrounds for Jewelry, Makeup, Product Shooting - Compatible with 5mm SnapIt Boards by Stuart Sugden

In case you're wondering, this will not hold Replica Surfaces panels. I actually had to snap this shot ASAP because it literally looked like it was going to fall over and ruin my very expensive board. In fact, if the stands were a bit taller I think they would fit. *Possible Modification: Add a foam sticker in one of the mounts to make your replicas thicker. Not sure if this works, just sounds like it might work to narrow any space between the board and the stand because the replica surfaces are thin but strong boards. a board called sandstone, that's one of my favorite types because I'm so tired of seeing marble. LOL😁 I've now tested it with a regular foam board and it held up, except foam boards are a lot lighter than replicas. I also cut the boards for a smaller display so they are lighter and hold the foam. But be careful. If you modify the foam it might be too thick to fit in the stand unless you just put some extra material right in the corners. because each one is thicker than regular foam board and you cannot insert foam board with modifications into these coasters.