Review on 📱 iRing Slide - A Convenient Wireless Charging Compatible Solution with Slide-to-Charge Feature. Includes Car Cradle/Wall Hook Mount. Discover the AAUXX Original Ring Grip Finger Holder Stand in Gold. by Chris Hernandez

Review updated. A decent concept would probably fit better on an iPhone than my s20fe. The supplied glue has a very short lifespan. I ordered them around April 20th 2021 today June 3rd 21 and they just fell out of my phone. Not recommended unless you intend to update every few weeks. Original Review: Pros: Adjustable, good glue included, seems to work almost as advertised (ish) Cons: Too big and too small, seems to work almost as advertised. The base of this thing is huge - I have a metal case on s20fe aka big@$$ device. Vertically, the base is half the height of the body, horizontally it reaches a level and hangs over the two sloping sides. The ring also protrudes greatly when folded. It's obscene. However, the ring itself is so small that the swivel (2nd/middle joint) does not fit. Roughly speaking, a diameter is about 2mm smaller than most other phones I've used. The glue is excellent. When I ordered one of these "thin" rings, it fell off within minutes. I've been sitting here spinning around and playing with this ring for half an hour and not a single hint of a problem. Almost as advertised. wireless charger. I chose to semi-permanently tape this beforehand and would definitely recommend doing the same. With the Anker charger, I've found several positions where wireless charging just doesn't work, only a few that do: horizontally top or bottom (no center), vertically down either the bottom half or top and vertically centered ( however, charging only works when the device is turned upside down). Abusing this on a device with an earlier operating system instead of checking the dock on it.