Review on Enhance Your Water Dispenser with the New Wave Enviro Dispenser Stand by Nicole Thomas

Made of shellac-like wood. The pieces I received had a few rough spots (slivers/burr). Each part of the stand is attached with glue, which can make it questionable how much weight it can safely support. Each part of the stand has a groove and one slides over the other. There is a few millimeters of play (the notch is too big) making it difficult to center properly. The round base plate (foot) should be painted white on one side (as shown on the product page). The ones I received in normal condition (as shown in my uploaded photos). It looks like a pressed board. The plate has five pre-drilled holes. There are no cross sections. This makes it very difficult to center properly - Moreso, given the gap in the crossbars. The kit should contain several smaller screws (two sizes) for the round plate and one larger screw for attaching the crossbars. Here, too, the cross has no pre-drilled holes, which makes it extremely difficult to screw in a larger screw. This was not a problem as my package did not include a larger screw. Also included were 5 very small screws of the same size to attach the round plate (instead of 4 of one size and 1 of another size as shown in the instructions shown in my uploaded photos). Please note that the 8 inch height widely used in reference materials is misleading. Importantly, the bottom plate coverage is only about 6 inches. This affects the size of the containers you can pour into unless you move the coaster to the edge of the raised surface it's standing on. be of poor quality. Overall, this is a disappointment, especially considering the high cost ($20). It's just not worth it on multiple levels. I plan to return the product (which is an additional problem).