Review on Screen Protector Widescreen Monitor Computer Computer Accessories & Peripherals by Fock Dean

Instructions were easy. Too simple. So I'll try to help a little.1. You may need to trim it: use a box cutter and ruler. Make it 1/16 inch smaller. 2. The material is hard but soft. It will scratch easily or soak up a bit of dirt or whatever, so only cut/work on a very clean surface. 3. If you try to break it, it looks terrible! Bubbles are everywhere and they don't come out easily, if at all. ), but I was lucky. 5. Wipe the screen with a clean cloth dampened with alcohol - do this twice - and let it dry. test run. 7. When finished, remove tape #1 and without laying it down, place an edge on one side of the screen. 2 inches at a time while gently moving your finger up and down to fasten without creating bubbles - see the bubble? Get up a little and start again.9. When you reach the last few inches, hold on tight or he may slip and jump onto the screen. Not the end of the world, but there may be some bubbles along the way.10. Once it's down, take a close look. Correct, clean, or start over before removing slide #2.11. That should do it! If you're wrong, you probably bought more than one in your pack, so you might as well start over - or no scratch - pun intended. Much luck. You can do that.