Review on 📺 PERLESMITH PSSFK1 Full Motion TV Wall Mount Bracket - Supports 13-42 Inch Flat/Curved TVs, Max VESA 200x200mm, Swivel, Tilt, and Extend - Holds TVs up to 77lbs by Arun Siddiqui

I'm a 50 year old female with no experience in these skills and have researched/checked ALL the complaints Installation B4: no problem for me either it took 25 minutes. Here is my research and solution to the most common complaints (using spacers also solves any tilt/sag issues) TVs from 19 to 22 inches, screw size is M4; however I have 32" and also M4 (30-40" could be M6) EXAMPLE: Included: M4 x 30mm Screws *TOO LONG* Part C1 (4) 2.5mm Part C2 (4) 22mm 👉 Spacers are used when the screws are too long or when there is a gap between the bracket and the TV. Most screws should have a gasket to allow airflow behind the TV etc. 👉Whether using gaskets or washers, the thread pitch is always 1.25mm, regardless of TV size. The purpose of most washers is to evenly distribute the load on the threaded connection with the material they are used with. For example, driving a screw into wood can cause the wood to crack across the entire surface. Washers reduce the risk of such damage by distributing the fastener load evenly over the material surface. Not all materials require the use of washers. With wood and other relatively soft materials, washers are useful to protect them from stress damage when driving a threaded fastener into the material. Contact with the object to be connected than with the side of the bolt. The number "1 mm" means 1 thread per millimeter. EXAMPLE: M6 refers to a 6mm metric screw. External thread diameter 6 mm. The standard metric screw is actually M6 x 0.1mm. The number 0.1 mm means 0.1 threads per millimeter. You can identify an M6 screw by a little over 7/32" (0.228") in diameter.