Review on Henrida Keyless Replacement Crosstour Screwdriver Interior Accessories ... Anti-Theft by Philip Anderson

Nice replacement key fob, better than the original, with logo sticker, screw and mini screwdriver. It has a plastic socket for the key shank that helps turn the key. Made from the same or very similar material as the original keychain. As for the case, it has no seams and very minimal or no creaking noise. When installing, be sure to align the shaft with the screw hole as closely as possible. The case is quite complex when it comes to the closure. Place it directly over the bottom, then gently push down and start on the sides until you hear a click, continue on both sides of the key and finally close the top where the key ring goes. Finish off the top with good hand strength or non-scratch pliers. Everything should be good and tight. When installing the screw, turn the screw with your fingers until the screw falls into the hole, then continue turning with the included screwdriver and you can get the screw under the surface of the keychain. If the screw does not fit, reassemble the key fob and adjust the key shaft by turning the bushing over or pulling down on the key shaft as far as it will go. Once your key is ready, keep the original if you are unsure if you need an RFID chip. To know this, your car must start and work (if the car does not start, then the RFID chip is still in the original key fob must be cut out and glued in place with double-sided tape or glued into the new key fob). Keychain in the picture is considered to be blue, more like a purple hue, but judge by yours. Thank you for reading this review