Review on 🔌 Cordless Air Duster 2.0: Electric Compressed Air Replacement - 80000RPM 55MPH - Cleaning Gaps, Computers, Keyboards - Replaces Compressed Air Cans - White by Brent Ayyagari

Very useful cloth for cleaning computers, dashboards, keyboards, air conditioner filters and even my office chair. The Cliklean vacuum has several advantages over compressed air canisters. This is "compressed air", it may contain a refrigerant (propellant) that is not really considered "air". For this reason, inhaling too many vapors (refrigerant/fuel) can lead to health problems. The Cliklean vacuum cleaner simply moves the same air into the environment and pushes it with the motor at high speed. Compressed air cans can spill liquid on delicate items. electronic components, Cliklean pneumatic duster does not work. Air tanks are good for short bursts. As they get colder, they lose pressure, and it does so in a matter of seconds. The Cliklean vacuum cleaner will continue to work until it needs to be recharged. Compressed air canisters will run out of air, but the Cliklean dust extractor can last much, much longer. Compressed air tanks may be cheaper to start with, but in the long run Rag compressed air tanks will save you money. LED light can be useful, so it's a nice addition. Despite being shaped like a jet engine, it's not as noisy as other devices I've owned. There are a few downsides that I feel are minor. .The atomizing power of Cliklean air atomizer is less than the starting power of can atomizer. Although the Cliklean air atomizer produces as much air as cylinders of compressed air, the initial blast performance is not as accurate. The width of the blowing tip is 5 times wider than the straw included in the set of compressed air bottles. The Cliklean vacuum can be very noisy, so keep your ears away from it as much as possible. Air gets into the block. The extension nozzle reduces performance and falls off. The brushes that came with it are useless. I would prefer a nozzle with a built in brush. When cleaning the fan blades, I keep the fan spinning with one hand and pick up the air cleaner with the other hand. I would need a third hand to clean the fan blades. There is no dust filter, so you can recycle and blow out the dust. Due to the bulky shape of the jet engine, this can be an issue if you have small or sweaty hands. Challenge so it doesn't slip. When I get very close to the surface (5mm or less) the device turns itself off unless it is fully charged. This can be annoying as cleaning the back streets of a motherboard (or similar hardware) requires a very painstaking job.