First of all, let me say that I'm new to this hobby and not very good with soldering irons. . However, installation was easy. Red to positive, black to negative (don't be put off by the yellow wire, I haven't used it), mount the camera and connect it to the receiver and you're ready for some FPV fun! I like that the camera and receiver are separate. I wanted my F36 to look as original as possible, so I hid the receiver under the I/O board and used foam packing material (supplied with the camera) and some hot glue to make a mount on the front of the drone, which I did did. no need to remove the canopy. I also upgraded my motors (since one of them blew up) and batteries to offset the extra weight, but I don't think that was really necessary.