Review on 💻 Enhanced Productivity and Convenience with Mount-It! Triple Monitor Mount: Adjustable Desk Stand Including USB and Audio Ports for 24-32 Inch VESA Screens, C-Clamp and Grommet Bases Included by Stacy Hall

For those wondering if this supports 32" curved monitors, yes. This requires some adjustments though, and in order for them to bend together you need to overlap the bezels. One issue I have with this mount is that the rotating screws used to move the monitors from landscape to portrait cannot be tightened. Mine aren't very loose, but it took a while to line them up properly and any effort on the corners will make them turn. As you can see in my photo they line up, but if you look at the left and center monitors you can see the overlap. If the left/right rotation on the monitor mount could go a few degrees inward past 90 degrees and the pivot screws could be tightened, this would be a 5 star product. Tips for those with 32 inch monitors, curved or flat, you should turn the adjustment screws counter-clockwise to tighten the gas springs (see photo). It takes a few turns to get it where it will hold the monitors. I recommend doing at least 10 full turns before putting the monitor on it because you can't really tell how stiff the spring is unless it's loaded, and the screws don't seem to tighten that much when you turn them . Also, be sure to tighten the vertical rotation (tilt) screws on all three brackets before attaching the monitor (see photo). If you don't do this, the weight of the monitor can cause the hinge to tip forward quickly and your monitor could be face down and damaged. the mount is just high enough for the monitor to sit on the table top. This will prevent the monitor from falling if the spring and pivot screws are not tight enough. Tighten the spring until the monitor starts to lift itself, and then slowly loosen it until the monitor is in the desired position. Then install the second monitor on the other arm in the same way. Finally, rotate the arms away from the center before adding the third monitor. Then make the necessary adjustments for the desired configuration. In order for 32 inch monitors to sit side by side like in my photo, the end arm sections need to be horizontal. When angled higher or lower, the external monitors start to overlap the center position. You can arrange the monitors in an inverted triangle. Configuration if you wish, but this requires you to place the center mount on the post in front of the side arms. would recommend it.