Review on 🔴 Allinoneparts Front Red Aluminum Grab Handle: Compatible with Jeep Wrangler JK JKU 2007-2018 by Mark Howard

Oh my god, there are some millennial whiners out there! I'm sorry your father didn't teach you basic mechanical skills and visual analytical thinking. Everything was fine with my paint - no stains, no chips. Installation? Yes, there are no instructions, but if you can't look at the pictures on amazon and understand them, well, you shouldn't be driving a jeep anyway! Seriously, I installed this in about 10 minutes at night using a flashlight and basic hand tools. You will need 5 6mm allen keys and a 13mm socket with a 3 or 6 inch extension. Using a 13mm socket wrench, remove the two bolts securing the visor and top of the A-pillar. Bad form if you slip you will hit the windshield and crack it. First mount the small part with two holes using the supplied short screws. The larger side of the cone faces up. Take the longer of the two long screws and thread it through the rounded tip, then through the hole in the handle, and then through the shorter hex piece. It fits into a hole in the A pillar. Using a 6mm hex wrench, screw it in just enough to hold it. Use the shorter of the long screws to attach the top of the grip to the sight mount with the tapered portion of the longer hex tube facing down. pull everything up This isn't rocket science and I should know since I was one of them. If you can figure out how to fit them in less than half an hour, then you've proved that you can buy cheaper Jeep parts in China. Now move on to something more advanced like a lightbar. It has to do with electricity.