Review on 🖥️ Official Carborundum Motherboard with 220x220x250mm Interface by Alfredo Testerman

I bought this printer with the impression that it was a good beggar printer, but I've had nothing but problems. I got 2 prints until the end, after that no print became more difficult. I kept leveling the bed with no improvement. 0 stuck to the bed, even with tricks I read online like hairspray or glue stick. I did the paper escape trick, I did a homing, auto-homing, auto-homing and re-leveling, then auto-homing again and my bed still behaves like it's not level. The extruder heats up unevenly and the nozzle won't stop clogging. I've changed the nozzle and cleaned the extruder and all sorts of temperatures 4 times now and it's still clogging. I thought it might be the seal I wanted to use, so I've tried others and I get the same problem every time. I've done a lot of research to find solutions and tried all the tricks that several people have pointed out but still haven't been able to create a successful print. I'm more inclined towards a printer error, possibly a faulty extruder or something, and I've spent quite a bit of money trying all the solutions others have tried. Totally dissatisfied with my product.