Review on 🖥️ Mount-It! Heavy Duty Single Monitor Arm Mount: Full Motion & Height Adjustable Desk Stand for 19-32 Inch VESA 75-100 Compatible Computer Screens by Tim Purdie

The MI-751 has arrived and works well with the HP LP2475w monitor. 4 stars because the 8 screws they say are included are actually 4 and that's all you need. I haven't used them. I replaced the HP base mounting screws with a VESA mount interface. A word of caution: use your thumb to pry off the sides. They are placed on the joints and immediately come off. A hex key is suitable for adjusting the desired installation. Tip: Attach the VESA mounting interface to the back of the monitor using the tabs underneath as described above. Turn your hand parallel to the monitor. Use a tape measure to measure the total distance from the other end of the monitor to the end of the mounting point that meets the vertical stand. Reduce this measurement [it's 24-26 inches] and go that distance from the outside edge of your table to the center. I have two monitors. My table is 62 cm wide. I made sure each monitor was 3-4 inches from the left or right edge of the table. In other words, I went left and right 30 inches. This leaves 2 inches between the rear mounted mainstay mounts. Four inches of sag on these 24-inch monitors gives some wiggle room. If you have 27-32 inch monitors, adjust them accordingly or choose a table that is 68-72 inches wide. I just used a two plate vertical stand configuration and a Vesa mount on the back. I believe everything else was extra for customization that someone else might need. Worth the $27 purchase price before the holidays. I definitely recommend it. I plan to buy another one. Note. The ball joint nut, which is tightened with the socket wrench provided, must be installed over the arm and under/under the arm. Why? The range of motion required to fully fix the position requires it.