Although this custom bezel looks identical to the standard front bezel, it has two problems. First, the screw holes are actually slightly smaller in diameter, and screwing the plate in causes a headache. Second, it is a complete set as a whole, reduced to two questions. First, the pelvis always seems more wobbly and floating higher than it should be. I'm not sure if it's due to warped plastic, screw pins that are too long, or some other weird reason. The second problem with the installation and the most critical problem is that the D-Pad does not work during the installation. Pointing down on the D-Pad puts pressure on the plate, which doesn't work. I measured against the factory faceplate and the measurements are accurate to tenths of an inch, so I'm not sure what the problem might be. Needless to say, I will be buying a new faceplate elsewhere.