Review on 📱 Black iPad 5 2017 9.7 inch (A1822, A1823) Touch Screen Digitizer Assembly Replacement with Home Button, Camera Bracket, Pre-Installed Adhesive, Tool Repair Kit from Zentop by Shane Wallace

You need a heat gun. Heat the edges of the screen and start pulling it up. You must start on the opposite side of the cable connectors for the display. Once disconnected, pull up as if opening a door. Remove all glass, use slime or essential oils to remove glue and tape from last display. After that, remove the LCD screen, then detach the LCD screen, and then you can detach the digitizer (touch screen) which is located under the connector of the LCD screen. At this point you should have 7 screws (4 for the LCD screen, 3 for the LCD connector). Plug in the new digitizer, clean the LCD with windex and alcohol if needed, windex is the last step with the microfiber. Remove the tape from the digitizer cable and stick it to the digitizer and the bottom of the iPad. Install LCD. Peel the tape around the digitizer and remove the protective cover from the back of the digitizer. Glue it to the iPad and then use the heat gun to melt the glue. Did.