Review on 📷 Transparent Clear SOONSUN Side Open Protective Skeleton Housing Case with LCD Touch Backdoor for GoPro Hero 4, Hero 3+, and Hero 3 Camera by David Fields

Exactly the case I was looking for. The skeleton has an open interface for USB ports, as well as an open LCD screen window for Go Pro users. I bought this skeleton for my Gitup Git2 camera. The button feels really good compared to my case which requires a bit of effort. Includes a rubber lens cap which is nice. Git2 Pro camera users should be careful not to hold down the camera's power button when the case is closed. The solution to this problem is to remove the power button through the micro retaining ring inside the case. Just hold the power button towards you and use a flat head screwdriver, to slide the ring off the pin. The button should fall out to the front. Be careful not to lose the locking ring! The next step requires special attention. Take a drill the same size as the retaining ring, measured from the bottom of the drill (flat side). Now carefully align the drill with the hole INSIDE the case and dig a little at a time. You want to remove enough plastic so the pin doesn't hit the power button on the camera when you close the lid. Set the drill to the lowest setting and use about 15% power. If you drill too far, it's game over for the power button. so that the pin does not touch the power button of the camera when the cover is closed. Set the drill to the lowest setting and use about 15% power. If you drill too far, it's game over for the power button. so that the pin does not touch the power button of the camera when the cover is closed. Set the drill to the lowest setting and use about 15% power. If you drill too far, it's game over for the power button.