Review on Bingfu Attachment Connector 10 Pack Compatible by Luis Tuazon

I would suggest that the plug should slide over the ferrule until the shell meets the nut BUT if you do this with the RG58 the ferrule will not fit the jacket. So first put a piece of shrink tubing (not included) over the cable, double the length of the ferrule, then cut the sheathing 12mm, cut the braid about 5mm, leaving 7mm, trim then strip away 3mm of the dielectric to expose the cable. central leader. Solder the center conductor, then insert it into the housing until it's slightly shorter than the edge of the connector. At this point, the braid should be touching the terminal nut and the shroud should be touching the end of the ferrule, BUT NOT ON IT. The crimp sleeve only crimps the braid onto the ferrule, NOT the jacket. Crimp the sleeve, then place the shrink tube on the crimp sleeve and shrink.