Review on End Flange Bearing Plates for Residential Application by Steven Cox

Coincidentally, the bearings in these end flanges were from the same manufacturer as my old ones. You can only order the bearings themselves a little cheaper. I ended up using a wooden 2x4 and C-clamps to pop out the bearings and press them into my old flanges that I left hanging on the wall. These flanges were installed about an inch farther from the wall than my old flanges, so I didn't want to mess with the alignment and stuff. It probably wouldn't have been a huge problem using them as they looked like they would work fine when I placed them against the door frame. Be sure to use some axle grease to lubricate the rod where it enters the bearing so the bearing doesn't cut through the thin-walled tube over time.