Review on Ailun iPad Pro 12.9-inch 2015 & 2017 Screen Protector - 📱 Premium Tempered Glass with Apple Pencil Compatibility, Ultra Clear, Anti-Scratch, Case Friendly by Kevin Johnson

02/15/2016. I just received this screen protector and installed it on my iPad Pro. It's quite thick but seems to work well with both the Apple Pencil and my finger. I'll provide an update after using it for some time, but so far it's sober and functionally good. The only downside was that the instructions were very inadequate for the average person who has rarely or never fitted a screen protector before. I have found that the following technique has worked well for me and allows for a bubble free installation. I used exhaled steam and a good quality lens cleaning cloth to remove any smudges from the screen. (I also assume a soft microfiber cloth will work as well.) I've found that using the included wet wipe requires further cleaning with my glasses cleaning cloth, as the included cloth leaves streaks. (I also found that due to its small size, it took longer to clean the screen with the included dry cloth, so I went back to my glasses cleaning cloth I.) I then used the included dust removal sticker, applied it in crevices, and peeled it off the screen screen until the screen is free of dust. I found a dust remover and this technique worked very well. (I suggest you test the screen protector before using the dust removal sticker, as a trial fit of the screen protector will leave more dust on the screen and you will need to dust the screen again with the dust removal sticker.) Keep in mind which edge of the iPad Pro does not covered with a protective film. Carefully remove the protective film from the screen. Place one of the long edges of the screen protector on the screen, touching only the edges of the screen protector. When the edge of the screen protector is aligned with the long edge and the same distance from the edge of the iPad Pro as when you tried it on, carefully place the screen protector on the display. Leave the protective film alone while you watch the protective film settle completely. If you have air bubbles, simply use your fingers or a stiff piece of cardboard to squeeze them out of the edge of the protective sheet. I then recommend that you press down on a hard, straight piece of cardboard from the center and work your way to the edge to allow the screen protector to fully adhere to the screen. The steps above worked fine for me, but you may have a better technique. Today is 7/27/2019 and this product is still working very well. I found this a great product.