Review on 🖥️ Supershieldz Clear Touch Bar Screen Protector for Apple MacBook Pro 13 inch (2016-2021 / M1) (A1706, A1708, A1989) - Set of 3, High Definition PET Shield by Dushawn Walker

If you can install it properly, it's completely invisible. No photograph can do justice to a perfectly made setup. It's not that hard if you understand exactly what you're doing and follow the instructions. PRO TIP: (This only works if you understand and follow every word before starting with a clear head and calm mind. I hope the long text helps people.) a long piece of clear tape to secure at the top edge . Screen. Don't peel off the tread film just yet - we'll do that later. (Tape should cover the entire top edge of the screen protector and also stick to the top edge of the screen to the back of the screen so you can flip the screen protector up, over and behind the screen.) The idea is that you use tape as a hinge to fold the protective film back and forth without losing the position. 2) Clean the screen - flip the protective film over to the back of the screen (with tape and films still running). Then tilt the screen so that it forms an angle of less than 90 degrees with the keyboard. (Opening about 70-80 degrees.) This means the screen is facing DOWN. This is necessary so that dust does not settle on it. Clean the screen with the supplied cloth (screen facing down). Be sure to inspect your work in bright light and make sure the screen is free of oil and dust. 3) Then we separate the inner film from the screen protector - - Keeping the screen tilted down, flip the screen protector onto the front of the screen, but don't let it touch the screen yet. It should hang with its top edge above the screen since the screen is facing down. Carefully peel off the inner film from the protective film, also without touching the screen. Now there should be no more dust on the screen and on the inside of the protective film. 4) Stick the screen protector to the screen - press the top edge of the screen protector (starting with the camera hole) onto the screen. The rest of the protective film should follow and start to set down to the bottom edge. You can help it move by tapping the screen protector lightly, but only on the parts that are already stuck. 5) Remove all bubbles - now you can fully open the screen and check your work. This isn't usually necessary, but if bubbles form, squeeze them out. 6) Remove the transparent tape. Carefully remove a long piece of tape from the top edge without removing the protective backing or outer film. 7) Remove Dust - For a few dust particles that fell under the protective film, use a new piece of tape to remove the protective film from the edge closest to the dust and use another piece of tape to remove dust particles to collect the inside. side of the SCREEN PROTECTOR (meaning the sticky side of the tape sticks to the INSIDE of the screen protector to remove dust). Each time you lower the protective sheet, let it close again and squeeze out any bubbles before moving on to the next speck of dust. 8) Remove the outer film - Carefully remove the outer film without removing the protective film. 9) Win - You now have a dust and bubble free screen protector, fitted to your screen with perfect alignment. If you don't get it right the first time, learn from your mistakes. Also, use a broken screen protector as a dust remover (if available). So place and stick the second screen protector before removing the first (unsuccessful) one. Maximum number of protective films used: 2.