Header banner
Revain logoHome Page
Ryan Ramirez photo
1 Level
759 Review
63 Karma

Review on 🏎️ 6 Pack Sublimation Blank Car Cup Holder Coasters - 2.56 Inches Absorbent Stone Coaster Blanks for Crafts - Ceramic Stone with Easy Finger Notch Removal - Auto Cup Holder Coasters by Ryan Ramirez

Revainrating 5 out of 5

Good work. in Interior

I bought these car stands for personal use. I used an Epson 1430 printer with sublimation inks, sublimation paper, thermal ribbon and Cricut Easy Press. I bought the images from Creative Fabrica. I heated my Cricut to a maximum temperature of 360F for 180 seconds. The first coasters I made I followed the recommended time of 200 seconds and it burned one of the corners. I don't mind as it's for personal use and you can't see it once it's in the cup holder. Clean the shiny side of the stand with a clean cloth. Place the sublimation paper on the shiny side. I attached two small pieces of thermal tape to opposite sides of the stand to hold them in place. I placed the stand in the center of the Easy Press cushion, shiny side up. I placed a piece of plain paper on top of the coaster and sublimation paper to protect my slight abs. I put on a light press and applied some pressure. Be careful not to apply strong pressure that may break the stand. This site doesn't have the good instructions you see from other sellers. DON'T FORGET to use the shiny side. I used the matte side first, following another reviewer's advice, and the colors were terrible as there is no sublimation coating on that side.

Pros
  • Automotive
Cons
  • Big and bulky