Review on 3-Pack Nintendo Switch Screen Protector - iVoler Transparent HD Clear Anti-Scratch Tempered Glass Screen Protector for Nintendo Switch by Dave Hersma

I chose this product based on over 1000 positive reviews and it did not disappoint. I love getting 3 screen protectors as it's nice to know that if you get caught in hair or dust due to the static electricity created when peeling the adhesive off, you can just throw it away and try again. I installed it perfectly on the first try and the screen is clean with no bubbles or dust. Here are my installation tips (disclaimer: this worked really well for me, but doesn't guarantee it's perfect for everyone): 1. Turn on the hot shower and close the bathroom door for 5 minutes (this is no joke - I took advantage of this advice, which I borrowed from someone else, because steam and evaporated water attach to free-floating dust and remove it from the air). If you care about the environment, plan ahead and put on a protective sheet after your shower. Re-enter the stuffy bathroom, turn off the shower, and give the bathroom a moment to dissipate the mist. 3. Attach the switch (no joysticks attached) and use the cloth provided to give the screen a good wipe - dry is most important to remove any oil/grease residue. 4. Remove the adhesive backing by gently holding the edges only with clean, dry hands.5. Line up a corner and the short edge (left or right - I started on the left as I'm right handed) and carefully keep the edges (distance from the edge of the screen) small and parallel.6. Start by sliding the screen protector down, trying to keep the top edge parallel to the edge of the display. If it tilts slightly, it is best to gently pull it back slightly, rotate it to align the top edge closer to parallelism, and then slowly lower the screen protector over the screen.7. If you do it slowly, the screen protector should push the air out naturally as it sticks to the screen surface. There may be some air around the edges, but a gentle swipe of your thumb across the glass from the center of the screen to the edges will push out any remaining air pockets.